Tags

, ,

After months of waiting, the 3D printer is finally ready to be used! Setting up was quite easy and using MakeWare is rather straightforward. See below for some photos!

2014-03-12 10.35.13

Printing the base

Printing the base

2014-03-12 10.34.26

2014-03-12 10.24.25

2014-03-12 10.34.54

Here are the products of the 3D printing! Have to remove the base in order to the final product.

supporting base

supporting base

Product of the 3D printing!

Product of the 3D printing!

Final Product + a pill

Final Product + a pill

I have to reprint because the pill can just nice fit into the hole but cannot fall out from it. Anyway the printing process was quite fast, about 20 minutes for a servo horn of 5cm in diameter and 0.5cm in height. Happy! but what’s next? :/ Everyone has started writing the FYP report. 😦

Advertisements